How To Adjust The Elevator For Accurate Leveling?
How To Adjust The Elevator For Accurate Leveling? I am facing challenge for setting leveling on the lift, of monarch drive system, it uses for sensors (two for up and down leveling, and other two for door zone) Those milimeters shows the position level of car door seal in relation to landing door seals, when […]
NPX UAX HVF NTVF SYK-HRL Elevator Modules Assembly
NPX UAX HVF NTVF SYK-HRL Elevator Modules Assembly 7MBP150RA120-05 IPM IGBT 7MBP75RA120-16 MCA Inverter Module 7MBP75RA120-05 MCA Inverter Module 7MBP75VB120-50 Inverter Module 7MBR50SD120 Inverter Module 2MB1200U4D-120 Elevator High Voltage Board Module 2MBI200VB-120-50 Power Module 14512582-A CM200DY-24H/NF IGBT Module CM200DY-24NF IGBT Module CM1400DU-24NF Elevator-Specific Module PT76S16A IGBT Rectifier Bridge MCA Elevator Power Module PT200S16 IGBT Driver […]
How To Resolve Error Code E83?
How To Resolve Error Code E83? Fault phenomenon: The elevator only works for a couple of minutes and then it blocks, displaying error 83. It also does not allow the doors to open. There is no explanation for this error code in the manual. We consulted the relevant technical personnel from the Monarch factory, and they stated […]
Happy New Year 2025
Happy New Year ！ As the New Year approaches, I want to take a moment to extend my heartfelt wishes to you and your loved ones. May this coming year bring joy, prosperity, and good health into your life. Thank you for your support and trust over the past year. I hope we continue to strengthen […]
How To Solve Error Code E017 of SI250 GEN2?
How To Solve Error Code E017 of SI250 GEN2? The meaning of E017: Speed CPU retry failed. The DSPH/W monitor has detected the issue, and even after the operation CPU attempts to re-execute the DSP more than 4 times, the DSP remains inoperative. In other words, if the operation CPU sends signals for retrying more […]
